Note that a 1k5 pullup resistor is needed between the 3v3 pin and the D+ pin or the host PC (Windows) will not recognise your board as a USB device.Red USB 5V to E5V (with jumper JP5 set to E5V).Identify the correct D+ and D- pins on other mbed boards, the ST Nucleo F411RE for example uses these pins: You can connect the USB power to VIN to power the mbed board from the Host PC when connected. On the mbed LPC1768 the USB connector should be attached as follows: This typically exposes four wires, Red, Black, White and Green. ![]() ![]() You can use an existing USB data cable and cut off one end. You can send throttle, rudder, and X, Y co-ordinates as well as button and hatswitch states. The USBJoystick interface is used to emulate a joystick (gamecontroller) over the USB port.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |